The important bit about servicing YOUR bike...
No two bikes are the same, so we tailor the servicing to fit your bike perfectly.
While all Ducati's are scheduled for servicing every 12 months, not everyone covers the same mileage every year, so we need to adjust the servicing accordingly.
If you have riden 3000 miles in 2 years you won't need as much done as a rider who has covered 12,000, equally 6000 miles round Brands Hatch is a long way so we are happy to adjust the service items to suit you and your Ducati.
All about us... We are, and always have been a workshop focused company. We are a small independent workshop that is fully authorised by Ducati to look after your bike.
All our workshop team are Ducati factory trained, very experienced and work only on Ducati motorcycles.
What does this mean to you? It means that your Ducati will be serviced to the highest possible standard by someone who not only knows how to carry out routine maintenance work, but knows exactly what to check on each specific model. We feel this is the only way to a well maintained Ducati.
Fully Authorised AND independant : We are a fully authorised Ducati dealer, but we remain independent, so you get the best of both: prior to 2005 we were a tiny workshop servicing Ducati's without any support or technical benefit of any connection to Ducati. We continue to be a small workshop where you and your bike get the personal attention we are known for, we now have all the the benefits of full support from the Ducati factory:
Moto Rapido are one of the few workshops that can offer the best of both...
We are proud that our servicing prices are as sharp as when we were a small stand alone workshop, so you get more without paying more.
'Ducati Oil Service'
Modern bikes require an annual service and oil change.
Due every 12 months or when the 'Oil Service' light shows on your dash. The milage interval varies with each model, typically between 7,500 and 9,000 miles.
This service can be carried out within a working day, you are welcome to wait or use our courtesy bike.
Price varies with model but is typically £199.
Only due when your Ducati reaches the specified mileage.
This is the specialist service where in addition to the routine maintenance, we check and reset the Desmodronic valve system unique to Ducati motorcycles. We also repalce cambelts where required and carry out some of the more indepth and specilaist service items to the motor and chassis.
Examples of when this is due (miles):
This service often takes more than a day to complete, so we offer a service courtesy bike or colletion and delivery.
Price varies with each model and requirement, typically this is approx £700.00
Please call us on 01962 877998 and speak to our workshop who can advise accordingly.
Models 1990 to 2006
This is to cater for bikes that are due the larger service because they have reached the time limit (2 year intervals) but have not reached the mileage (12,000 intervals). This is 'Service 3 lite'
This option excludes mileage only items, such as the front fork strip and refresh (only really required at 12000 mile intervals) so your bike gets just what it needs and you're not paying for service items not required.
It is rare that these motorcycles fit into the service schedule set out by Ducati, so we are completely flexible to our approach to what these bikes need. Call the workshop on 01962 877998 and we can advise what work is needed.
These are the some of the more specific service options available in the Moto Rapido workshop. Below are the most popular options for the dedicated Ducati owner, for the rider or racer who wants the very best out of their bike, developed from our experience with our own Ducati's on road and track, this is the kind work that our reputation is built on. Not available at your average Ducati dealer!
Desmodromic head Refresh: (aka Top end blueprint)
The desmodromic valve operating system used by Ducati is, as all race derived systems, particularly sensitive to the components being set perfectly, so worn rockers or camshafts, valves not seating properly or covered in exhaust carbon and unmatched shim tolerances all result in poor running, difficult starting, poor throttle response, less power and increased oil consumption.
Therefore we offer a full top end rebuild as an upgrade to scheduled servicing. Although during every service we check the condition and clearances of the valve system, our experience has shown that engines with 15000 - 18000 miles (average road use) really benefit from this refresh. Note: For dedicated track or race use we tend to do this service once a season
(depending on the level of tune of your engine)
This is often refered to as a 'top end blueprint' and is very popular with our track day customers and racers, setting the desmo valve system to exact tolerances, rather than factory built ones, simply makes your Ducati as it should be. We often do this service along with cam timing (see below) to get the best out of the desmo V twin engine.
We remove both cylinder heads, strip and professionally clean them completely, de-coke and pro clean the pistons, barrels and heads, check valve guide condition and replace if required (usually 24000 miles of road use) clean and lap the valves / valve seats, replace worn rockers, replace collets and stem seals. Then assemble each head and set the valve clearances exactly, clean barrels/cases and replace base gaskets and refit the heads.
This upgrade is a complete top end rebuild, and you will notice the difference, more power, smoother running and sharper throttle response are the ususal remarks from customers.
2 valve per head motors - £370 + parts required
4 valve per head motors - £435 + parts required
4 valve per head Testastretta - £435 + parts required
4 Valve per head CORSE / RS / Factory bike - £POA (Race schemes available)
Testatretta Evo motors : These motors suffer far less than the previous models and its rare we see worn rockers and cams prior the service interval of 7500 (for road bikes).
As each motor requires different parts, these prices exclude the cost of gaskets, O rings, stem seals and valve collets etc that your bike would need. Other parts (valves, rockers, valve guides, cams, cam bearings etc) are in addition and we will advise accordingly. No additional labour is charged for fitting these as part of this service.
The fun bit...
As we have the heads apart and on the bench for this service, upgrade Camshafts, race rocker springs, R/RS/Corse rockers, rocker covers etc are fitted free! and it is an ideal time for head porting / gasflowing !
This is a MAJOR Rebuild (sometimes and called 'Blueprinting') specifically designed by us to get your Ducati running and handling the very best it can.
Every motorcycle is built to a manufacturing tolerance rather than being hand build precisely. This service changes that, this is why we get such good results by carefully setting everything to the exact settings.
We are happy to advise and amend the list of service items on this and all our services to suit your bikes needs exactly - Just call the workshop to go through what your bike specifically needs. This is where our workshop really gets its reputation, there are many Ducati trained mechanics but few can strip and rebuild a motor to this specification. The same people who build our race motors, carry out this level of engine work. Precision and attention to the finest detail are everything.
Everything included in the the major service for your bike PLUS a total engine build as follows...
This is a very involved job, clearances can be changed by altering base gasket size or machining of the barrels
A very worthwhile note… We can now remap the majority of Ducati ECU's and eprom chips in house. So if you have a special requirement for your 1098 / 848 / 999 etc we can now reamp these ECU's with upgraded fuel tables, ignition tables, alter RPM limits etc, just call (some more info CLICK HERE).
(Please note: a running in period is required for new piston kits before we can run your bike on the dyno)
Service labour Prices…
2 valve per head motors - £995
4 valve per head motors - Desmoquattro: 748 / 851 / 888 / 916 / 996 - £1100
4 valve per head motors Testastretta: 996R / 998S / 998R / 749 / 999 - £1100
4 valve per head Testastretta Evolution motors: 848, 1098 /1198 / Streetfighter - £1100
4 Valve per head CORSE / RS / Factory bike - £POA (Race schemes available)
** Upgrade or performance parts marked are fitted free as part of this service, many other tuning parts (engine parts, exhuast systems etc) are also available with free fitting when we have your bike on the operating table for this service, speak to us about what you would like your Ducati to do and we can go through the options.
Prices exclude parts required (as these vary greatly between individual bikes)
Again, a matter of getting your Ducati running just right. Perfect Cam timing is critical to getting the most out of the Ducati motor, often overlooked in favor of big exhaust kits or high compression pistons. this is an excellent way of getting more from your motor without spending fortunes.
We have many sets of cam timing, each designed for a particular task and model, more top end power, more mid range or more bottom end grunt.
The latest generation of motors (Testastretta superbike, monster and Multistrada) have adjustable cam pulleys fitted as standard so there is little expense, an ideal upgrade to scheduled services.
Previous models can be fitted with lightweight adjustable pulley sets too.
Prices for cam timing: Cam timing is charged at our regular service labour rate (£55.00 per hour) as some models take longer than others to set up. It takes approximately 4-5 hours, less if done during a service.